IPV6 LOOPBACK ADDRESS DRIVERS
IPV6 LOOPBACK ADDRESS ARCHIVE

Dont worry about it - if its pinging other machines correctly its working as it should. IPv6 is built into these OSes & cant be completely disabled. I have been doing some reading on IPv6 and have read a few different best practices guides and all of them seem to have conflicting information on the best way to assign loopback addresses.

Add check to drop those addresses.ДЇixes: f1705ec197e7 ('net: ipv6: Make address flushing on ifdown optional')ДЎ file changed, 10 insertions(+), 2 deletions(-)Дiff -git a/net/ipv6/addrconf.c b/net/ipv6/addrconf. Even if you disable IPv6 when pinging localhost on Server2K8 or Win7 youll get a reply from the IPv6 loopback address (::1). Loopback addresses are also retained which is not part of the objective A side effect of this change is that link local and IFA_F_PERMANENT flag rather than adding a user_managed boolean to the

IPV6 LOOPBACK ADDRESS DRIVERS

The loopback interface allows IT professionals to test IP software without worrying about broken or corrupted drivers or hardware. The IPv6 loopback address (::1) is not used in Event logs. In Release 7.3 and Release 8.0, the loopback address shown in the system Event logs is the special IPv4 loopback address (127.0.0.1). It must not be assigned to a physical or virtual interface. A comment to one of the later revisions suggested using the The loopback interface has no hardware associated with it, and it is not physically connected to a network. The loopback address may be used by a node to send an IPv6 packet to itself. 3:00 ` David Miller 0 siblings, 1 reply 3+ messages in threadДЇ1705ec197e7 added the option to retain user configured addresses on anДЄdmin down. These addresses can be used on the Internet. The global unicast IPv6 addresses are similar to IPv4 public addresses. There are a number of different unicast address types that weвЂ™ll discuss here. If an application in a host sends packets to this address, the IPv6 stack will loop these packets back on the same virtual interface. These are meant to configure on one interface so that you can send and receive IPv6 packets. The loopback address is a unicast localhost address. This loopback address is so lengthy and can be further simplified as ::1/128.

If an application in a host sends packets to this address, the IPv6. Unicast IPv6 addresses are similar to unicast IPv4 addresses. In IPv6, the IPv6 address reserved for loopback use is 0000:0000:0000:0000:0000:0000:0000:0001/128.

IPV6 LOOPBACK ADDRESS ARCHIVE

Net: ipv6: Do not keep linklocal and loopback addresses Netdev Archive on help / color / mirror / Atom feed * net: ipv6: Do not keep linklocal and loopback addresses 19:01 David Ahern The loopback address is a unicast localhost address.

Ipv6 loopback address